Engine: There are too many to count as toyota used them in alot of vehicles
3VZ-FE toysrme?
4VZ-FE JDM?
5VZ-FE Found in 1995.5-2004 Tacomas, 96-02 4runner, 95 T100(Rumor has it this was a Disti 5vz),00-03 Tundra -Weasy2k
1MZ-FE 94-99 Avalon, 94-02 Camry, 99-02 Solara, 98-03 Sienna
1MZ-FE*^ 03-04 Camry/Solara
1MZ-FE* 98-99 es300/rx300, 00-04 avalon/sienna 01-04 highlander
2MZ-FE* JDM?
3MZ-FE*^ 03-05 highlander, 04-05 Sienna, [...]
MK2 V6 Engines
Toyota V6 Swap Candidates
By Oteck
View the original content on International MR2 Owners Club
-
Why the 3vz-fe is the Best Toyota v6
By Toyrsrme
This doesn’t include the newest v6’s coming. I.E. the new onslaught from the Lexi, or the 4.0L v6.
Comparing 2vz-fe, 3vz-e, 3vz-fe, 5vz-fe, 1mz-fe
(For the purpose of the discussion 1mz-fe = all 1mz-fe’s, 1mz-fe1 = non vvt-i 1mz-fe’s, 1mz-fe2= vvt-i 1mz-fe’s)
2vz-fe – has the weakest parts & should be avoided. 90-91 have o2 sensors.
3vz-e – can [...]View the original content on International MR2 Owners Club
-
V6 How To-A Visual Aid
By Node
Removal of the stock motor 3S or 5S. Keep the parts organized, you will be using many on the V6 motor.
Things to remember:
Cap off coolent hoses
Protect fuel lines from contaminants and dont loose the banjo bolts and crush washers.
DONT CUT your wire harness, if your using a stock ECU you will be grafting the old [...]View the original content on International MR2 Owners Club
-
How to Build an Oil Filter Relocator
By Toysrme
Instructions:
There isn’t anything to say that isn’t obvious. Take the stock Toyota oil filter stand- off & cut it in half. Tap (& drill if needed) the channels to accept your hose barbs. Put your sealant around the threads & tighten (15ft-lb, or pretty hand tight is good enough). [...]Tags: CEL, code, filter, install, remove
View the original content on International MR2 Owners Club
-
Solving The Valve Cover Gaskets, Permanently
By Toysrme
I didn’t write this for yall, as most of you guys have obviously not experienced leaking valve cover gaskets. (yet) I figured maybe some of you guys doing your swaps could save a lot of trouble for yourself down the road.
This is a “your thoughts” thread. I’m not saying this is how to do it [...]View the original content on International MR2 Owners Club
-
V6 Swap Primer
By Brad Bedell
Engines: Compatiblity / Grocery List
1997+: 1MZ-FE
Best choice for swap.1992-1996: 1MZ-FE
Compatible, but not recommended.
Early 90’s 3vz is proven to work also*
[...]Tags: adjust, belt, CEL, code, codes, conversion, ECU, engine, filter, install, pedal, remove, swap, transmission, TRD
View the original content on International MR2 Owners Club
Page 1 of 11
