This is a fairly easy fitting. You have to make sure your measurements are right, and that you have confidence to drill into your engine lid. This type of spoiler was originally available in both the UK and the USA. I bought mine from the States (DirectCarToys), so of course the following information only relates [...]
MK3 Body
-
Euro Side Repeater Replacement
By StuM
A small mod it may be, but side repeater replacement (for pre-facelift cars) is one of the most effective, and thus popular. I have just done mine, so decided to take a few pictures to help anyone else looking to do this. The parts: * Clear facelift side repeater lenses – £22 from CTP (inc [...]
View the original content on MR2 Roadster Owners Club
-
Netz Style Bar Install
By Nelix
First of all a disclaimer- I am not a professional, merely an ungifted amateur. This guide is simply how I installed my Netz style bar and I accept no responsibility for any damage or accidents you incur if you choose to follow this guide. This was bought from Japanparts through Spyderchat as members get a [...]
View the original content on MR2 Roadster Owners Club
-
Meshing the Sidevents
By Perry190
Removing the old vents First of all you need to remove the actual plastic vent from your car. It is held in place by three clips along the front edge and two protruding clips/lips, one top and one bottom. All of these clips are designed to be pulled apart, so I’m afraid its just a [...]
Tags: grill, mesh, side vents
View the original content on MR2 Roadster Owners Club
-
Pelican Racing Front Grill
By Andrew Carter
Heres the one i made from some Foliatec Racing Mesh to start with. The results came out ok, but as you can see after a year or so it looking pretty tatty. So time for new one, so simple snip of the cable ties and out it came. Normally it would just be the case [...]
Tags: front, grill, mesh, Pelican Racing
View the original content on MR2 Roadster Owners Club
-
Rear Bumper Removal
By Kanujunkie
(1) – To start with I disconnected the rear lights; this is done by removing the2 screws at the front and side of the main light unit.There is also a small plastic spigot (location shown in Green) that goes into the wing, please be very careful when removing the unit as this could be snapped [...]
Tags: rear bumper, removal
View the original content on MR2 Roadster Owners Club
-
Carbon Fiber Scuff Plate
By Andrew Carter
What the kit contains: 2 x Garnish Film Strips (Left & Right Identical) 1 x 3M Adhesion Promoter 1 x Applicator Thoroughly clean the surfaces of the plastic scuff plates with methylated spirits. Treat the surface to be covered only, with the 3M automotive adhesion promoter sponge. Repeat this for the other side of the [...]
Tags: carbon fiber, scuff plate
View the original content on MR2 Roadster Owners Club
-
Engine Lid Mesh
By Southerneditor
This is a mod I’ve been wanting to do for a long time. The various threads that discuss the matter indicate that no damage results from removing the engine lid drip tray, and that better cooling results. First, I had to consider my location and driving style. It is very hot here in Florida, so [...]
Tags: engine lid, grill, mesh
-
Body • Body • Body • MK1 • MK2 • MK3
Exterior Detailing 101
By Dev
This is going to be a three part series into exterior detailing. Our test subject is my sisters Black 2000 Toyota Camry with many paint imperfections and blemishes. After the detail is complete I will detail my Spyder which has the same paint code and post the corresponding pictures but I may take it one [...]
Page 1 of 11