This is a “how to” with some pictures that may assist in taking out our manual tranmissions. If your doing the removal yourself like I did you should alot 4 …

Yesterday I started grinding and sanding down my calipers. Living by the beach does cause a bit of corrosion. It took the good part of the afternoon to get them to a point that I felt it was good for painting.

Step one.
You should have everything apart and the key focus is the hard part which is passing the cable though.

Step Two
You need to cut the cable here.

The cable will …

Welcome back to the SE garage, where our mistakes become your after-dinner conversation.
Rear swaybar installation parts list:

1. Addco 7/8 swaybar
2. 2sRus High and Tight rear endlinks
[...]

Okay here’s a write up for an air filter change. Some things may vary since I have no heat shields but this should get you through it for the most part.

Tool needed-

Phillips screwdriver

Parts needed-

New airfilter

Begin.

P0100 Mass or Volume Air flow Circuit Malfunction
P0101 Mass or Volume Air flow Circuit Range/Performance Problem
P0102 Mass or Volume Air Flow Circuit low Input
P0103 Mass or Volume Air flow Circuit …

Adjusting The Clutch Pedal
Ok I’ve read “Path To Shifting Nirvana” And it wasn’t quite clear to me on how to actually adjust the pedal. So I took some a picture …

Bleeding The Clutch

Tools:

8mm Wrench
Air Compressor
Power Bleeder
Fluid Supply Bottle
Lift or Jack/Jack Stands

1. Jack up car and set on jack stands. (Or use your lift)
2. Use the power bleeder to suck out …

Changing The Clutch Line
Tools:

10mm Line Wrench
12mm Line Wrench
Regular Pliers
Lift or Jack/Jack Stands

Something I have been putting off for years (literally) because I didn’t want to deal with the hassle is flushing out my brake fluid. Finally I found the griots garage one …