MAF
Okay here’s a write up for an air filter change. Some things may vary since I have no heat shields but this should get you through it for the most part.
Tool needed-
Phillips screwdriver
Parts needed-
New airfilter
Begin.
Tags: air filter, filter, guide, MAF
Yes, there is a SpyderMagazine article on this. But, I thought, it assumes you already know WHERE the Mass Air Flow sensor (MAF) is. So I thought I could make it more simple. N00b-proof, if you will. Hey, I’m learning too–may as well share the process. The engine should be cool for this procedure, or [...]
Tags: cleaning, ECU, engine, guide, MAF, remove, reset
When I tried to add these pics to the n00b’s guide on MAF cleaning, it said there were too many pics. So, it gets a thread all by itself. When you clean the MAF, you should “reset” the Engine Control Unit (ECU) to put it through a “re-learning” process. You should do this when you [...]
Tags: air filter, cleaning, ECU, engine, filter, guide, MAF, remove, reset
First off I’ll talk a little about how I “determined” my motor was bad. I was poking around in the frunk when the fans came on and I looked down to see that only the driver’s side fan went on. After the car was off I spun the fan blade with my hand and found [...]
Tags: cleaning, code, ECU, guide, install, MAF, remove
Disclaimer: This documentation in no way replaces the Toyota MR2 Repair Manuals. The purpose of this content is only to provide supplementary information to fellow MR2 enthusiasts. Midship Runabout and its contributing authors will not be held responsible for any injury or damages that may occur as the result of practicing any of the methods or procedures described within this website.