tensioner
Here are some tips and info on how to degree cams for the 3SGTE. This article does not cover cam install, just the degreeing process for aftermarket cams. If you do not degree your aftermarket cams, or use the stock cam gears with them, you are seriously cutting down on the power potential and driveability [...]
Tags: adjust, belt, ECU, install, remove, reset, tensioner
View the original content on MKII MR2 Mod Project
Here’s a summary of the smaller things that you will need to do that aren’t big enough for their own page: Fuel line Contrary to what was previously on this page, the 16V fuel line fits fine with no modifications (both SC & NA). I mistakenly used the 20V line which needed to be extended. [...]
Tags: adjust, air filter, belt, CEL, Clutch, ECU, engine, filter, pedal, remove, strut, swap, tensioner, transmission
View the original content on MK1 MR2 Write-ups
After a leak that had been going on for a couple months, I decided I would go after changing out the water pump. I also wanted to flush out the entire coolant system as this hadn’t been done since I had the car. I ordered the new water pump from Jay Marks Toyota. About $60 [...]
Tags: adjust, belt, CEL, drain, drop, ECU, engine, guide, install, removal, remove, spring, tensioner, water pump
View the original content on MK1 MR2 Write-ups
Some of these pics are out of order, so you may see a belt in a pic that should have been removed, or a timing cover. I took these pics over a time period of 2 months. This work was done on Pat’s first MKIIT which had been sitting for exactly one year before the [...]
Tags: adjust, belt, CEL, engine, guide, install, removal, remove, reset, service, strut, tensioner
View the original content on MKII MR2 Mod Project
Note: This only pertains to the N/A MKI MR2s since the SCs alternator is located on the exhaust side of the engine. Got the 3 warning lights (Charge, Cooling Fan, Brake) on your dash shining in your face? Bad voltage regulator that is built into the alternator. Got one warning light (Charge) on? But don’t [...]
Tags: adjust, alternator, belt, drop, engine, install, removal, remove, replacement, tensioner
View the original content on MK1 MR2 Write-ups
Disclaimer: This documentation in no way replaces the Toyota MR2 Repair Manuals. The purpose of this content is only to provide supplementary information to fellow MR2 enthusiasts. Midship Runabout and its contributing authors will not be held responsible for any injury or damages that may occur as the result of practicing any of the methods or procedures described within this website.